1 / 61

6. Thermodynamic Cycles

6. Thermodynamic Cycles. Objective Classification of Thermodynamics Cycles Analysis & Calculation of Power Cycles Carnot Vapor Cycle, Rankie Cycle, Regeneration Rankie Cycle,Reheat Rankie Cycle Cogeneration Gas Refrigeration Cycle Vapor-Compression Refrigeration Cycle Refrigerant

dorit
Download Presentation

6. Thermodynamic Cycles

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. 6. Thermodynamic Cycles • Objective • Classification of Thermodynamics Cycles • Analysis & Calculation of Power Cycles • Carnot Vapor Cycle, Rankie Cycle, Regeneration Rankie Cycle,Reheat Rankie Cycle • Cogeneration • Gas Refrigeration Cycle • Vapor-Compression Refrigeration Cycle • Refrigerant • Other Refrigeration Cycles

  2. 6.1 Classification of Thermodynamics Cycles Power Cycle (+) Heat Energy Mechanical Energy Heat Pump Cycle (-) Refrigeration Cycle: keep low temperature of heat source with low temperature Heat Pump Cycle: keep high temperature of heat source with high temperature Working Fluid Gas Cycle: no phase-change of working fluid during cycle Vapor Cycle: phase-change of working fluid during cycle Combustion form

  3. 6.2 Carnot Vapor Cycle Several impracticalities are associated with this cycle: 1. It is impractical to design a compressor that will handle two phases for isentropic compression process(4-1). 2. The quality of steam decrease during isentropic expansion process(2-3) which do harm to turbine blades.

  4. 6.2 Carnot Vapor Cycle 3. The critical point limits the maximum temperature used in the cycle which also limits the thermal efficiency. 4. The specific volume of steam is much higher than that of water which needs big equipments and large amount of work input.

  5. 6.2 Carnot Vapor Cycle

  6. S 6 1 4 2 3 6.3 Rankine Vapor Cycle Principle 4-6 Constant pressure heat addition in a boiler 6-1 to Superheat Vapor 1-2 Isentropic expansion in a turbine 2-3 Constant pressure heat rejection in a condenser 3-4 Isentropic compression in a pump

  7. 6.3 Rankine Vapor Cycle

  8. p S 6 p1 1 4 5 6 1 4 p2 3 2 v T 2 1 5 3 6 4 2 3 s 6.3 Rankine Vapor Cycle

  9. 6.3 Rankine Vapor Cycle Efficiency 4-5-6-1 Constant pressure heat addition in a boiler 1-2 Isentropic expansion in a turbine 2-3 Constant pressure heat rejection in a condenser 3-4 Isentropic compression in a pump

  10. 6.3 Rankine Vapor Cycle Because of uncompressibility of water

  11. 6.3 Rankine Vapor Cycle Definition: d — the steam required to generate work of

  12. 6.3 Rankine Vapor Cycle Influencing factors

  13. 1’ 1 5’ 5 4 3 2’ 2 6.3 Rankine Vapor Cycle 1. - Pressure of Steam, Turbine Inlet -Unchange Two Cycles: ① 3-4-5-1-2-3 ② 3-4-5’-1’-2’-3

  14. 1’ 1 5’ 5 4 3 2’ 2 6.3 Rankine Vapor Cycle Disadvantages: 1. decrease the turbine efficiency and erodes the turbine blades. Increase of requirements on pressure vessels and equipment investment. 2.

  15. 1’ 1 5 6 4 3 2 2’ 6.3 Rankine Vapor Cycle 2. - Temperature of Steam, Turbine Inlet -Unchange Two Cycles: ① 3-4-5-6-1-2-3 ② 3-4-5-6-1’-2’-3

  16. 1’ 1 5 6 4 3 2 2’ 6.3 Rankine Vapor Cycle Advantages: i ii it decreases the moisture content of the steam at the turbine exit. Disadvantages: Superheating temperature is limited by metallurgical considerations.

  17. 1 6 5 4 4’ 2 3 3’ 2’ 6.3 Rankine Vapor Cycle 3. - Condenser Pressure, Turbine Exit -Unchange Two Cycles: ① 1-2-3-4-5-6-1 ② 1-2’-3’-4’-5-6-1

  18. 1 6 5 4 4’ 2 3 3’ 2’ 6.3 Rankine Vapor Cycle i Disadvantages: ii i Condense pressure is limited by the sink temperature. ii It increases the moisture content which is highly undesirable.

  19. 6.3 Rankine Vapor Cycle Example • Consider a steam power plant operating on the ideal Rankine • cycle. The steam enters the turbine at 2.5MPa and 350℃ and • is condensed in the condenser at pressure of 70kPa. Determine • The thermal efficiency of this power plant • The thermal efficiency if steam is condensed at 10kPa • The thermal efficiency if steam is superheated to 600 ℃ • The thermal efficiency if the boiler pressure is raised to 15MPa while the turbine inlet temperature is maintain at 600 ℃

  20. State 1: State 2: Ideal Rankine Cycle

  21. State 3: State 4:

  22. 6.3 Rankine Vapor Cycle Actual cycle Irreversibility • Flow friction • Heat transfer under temperature • difference • Heat loss to the surroundings

  23. 1 5 6 3(4) 2 2’ 6.3 Rankine Vapor Cycle Actual Rankine Vapor Cycle Turbine Efficiency Consumed Steam kg/h Ideal Cycle Actual Cycle

  24. 6.3 Rankine Vapor Cycle Mechanical Efficiency Relative Effective Efficiency Effective Power Boiler Efficiency Equipment Efficiency

  25. T 1 6 5 7 2 3(4) e d s 6.4 Improvement to Rankine Cycle 预热锅炉给水,使其温度升高后再进入锅炉,可提高水在锅炉内的平均吸热温度,减小水与高温热源的温差,对提高循环效率有利。 利用汽轮机中的蒸汽预热锅炉给水,称为回热。 Transfer heat to the feedwater from the expanding steam in a heat exchanger built into the turbine ,called Regeneration. Disadvantages: It is difficult to control the temperature The dryness is small

  26. T 1 6 5 7 2 3(4) e d s 6.4 Improvement to Rankine Cycle Ideal Regenerative Cycle Regenerative Cycle: 1-7-d-3-4-5-6-1 General Carnot Cycle:3-4-5-7-d-3 Ideal Carnot Cycle: 5-7-2-e-5 Same Efficiency

  27. 1 Turbine Boiler 7 2 Regenerator Mixing Chamber Condenser 4 6 5 3 Pump II Pump I Ideal Regenerative Cycle Extracting Regeneration

  28. T 1 1kg 6 akg 7 5 (1-a)kg 3(4) 2 s Ideal Regenerative Cycle >0

  29. T 1 9 8 6 7 4 5 3 2 s Ideal Regenerative Cycle 1 Turbine Boiler Regenerator 7 2 Mixing Chamber 8 Cond- enser 9 4 6 5 3 Pump II Pump I

  30. 6.3.2 Ideal Reheat Cycle 蒸汽经汽轮机绝热膨胀至某一中间压力时全部引出,进入锅炉中特设的再加热器中再加热。温度升高后再全部引入汽轮机绝热膨胀做功。称为再热循环。

  31. 1 a 5 b 6 4 3 c 2 Ideal Reheat Cycle intermediate pressure

  32. 1 Turbine Boiler 7 2 Regenerator Mixing Chamber Condenser 4 6 5 3 Pump II Pump I 6.4 Improvement to Rankine Cycle Extracting Regeneration

  33. 6.4 Improvement to Rankine Cycle Cogeneration • Definition • Cogenerationis the production of more than one • useful form of energy from the same energy source. • electric power • heat in low quality

  34. 6.5 Gas Refrigeration Cycle Ideal Reversed Carnot Cycle T1 — Temperature of heat source with high temperature, surrounding temperature T2 — Temperature of heat source with low temperature, cold source q1 — Heat rejected to the surroundings q2 — Heat absorbed from cold source w0 — Work input

  35. Condenser 3 2 Compressor Turbine 1 4 Cold Source 6.5 Gas Refrigeration Cycle 1-2 Isotropic Compress 2-3 Isotonic Heat Rejection to Surrounding 3-4 Isotropic Expansion 4-1 Isotonic Heat Absorption

  36. p 3 2 4 1 v T 2 3 T3 T1 1 4 s 6.5 Gas Refrigeration Cycle Cp— Constant, Ideal Gas • Heat Absorbed from Cold Source • Heat Rejected to the condenser • Work of Compressor • Work of Turbine

  37. T 2 2’ 3 3’ T3 T1 1 4’ 4 s 6.5 Gas Refrigeration Cycle

  38. 4 3 Condenser 2 Turbine Compre- ssor 5 1 6 Cold Source 6.5 Gas Refrigeration Cycle T 3’ 3 4 2 5’ 5 1 6 g k m n s

  39. Vapor-Compression Refrigeration Cycle • Shortcomings of Gas-Compression Refrigeration Cycle • 1.small Refrigeration-Coefficient because heat absorption • and rejection are not isothermal process; • 2.Lower refrigeration capability of refrigerant (gas) • So…refrigerant is changed to Vapor • The highest efficiency is that of Vapor Carnot Reverse Cycle Impracticalities: 1.Large moisture content is highly undesirable for compressor and turbine. 2.Work output is limited by liquid expansion in the turbine.

  40. Vapor-Compression Refrigeration Cycle • So…practical vapor-compression refrigeration cycle is: 2 2 3 4 3 4 1 1 6 5

  41. 2 4 3 1 6 5 Vapor-Compression Refrigeration Cycle

  42. 2 4 3 1 6 5 Vapor-Compression Refrigeration Cycle Throttle: ① fluid with low quality is difficult to be compressed. ② work loss is relatively small ③ easily adjust pressure of fluid and temperature of cold source Work difference between Turbine and throttle

  43. Vapor-Compression Refrigeration Cycle Regeneration — more realistic cycle Advantages: 1. 2. 3.Superheated vapor is desirable T 2 Super- cooled Liquid 3 4 4’ Superheated Vapor 1’ 5’ 5 1 s

  44. Condenser 2 4 1’ Compressor Regenerator Throttle Valve 4’ 1 Cold Source 5’ Vapor-Compression Refrigeration Cycle Conditions:

  45. 4 3 2 2’ 5 1 Vapor-Compression Refrigeration Cycle Irreversibility 1-2’ Isotropic Compress Efficiency 制冷机的制冷能力是随 工作条件不同而变化的, 因此,给出制冷能力时, 必须指明相应的工作条件。

  46. 6.7 Refrigerant Definition The work fluid cycling flowing in refrigeration system while transferring energy with surrounding in order to refrigerate. • Thermodynamic Request • Critical temperature should be much higher than temperature • of surroundings. • ① steam easier be condensed; • ② larger range of latent heat; • ③ heat absorption and heat rejection closer to • isothermal process

  47. 6.7 Refrigerant • Thermodynamic Request • Solidification temperature should be lower than evaporation • temperature to prevent blocking the pipes. • Larger latent heat is more desirable. • appropriate saturate pressure • small • being nontoxic ,non-corrosive, nonflammable, chemically steady; • low cost Environment & Safety Request Ammonia 氨 , Feron 氟利昂

  48. 6.8 Absorption Refrigeration System Definition The form of refrigeration that inexpensive thermal energy instead of mechanical energy or electric power is consumed to transfer heat form low temperature to high temperature is absorption refrigeration. Geothermal Energy Solar Energy Absorption refrigeration system involves the absorption of a refrigerant by a transport medium . Ammonia — Water NH3- H2O Water — lithium bromide H2O- LiBr

  49. Q-Solar Energy Q1 Generator rectifier Q4 NH3-H2O Condenser Adjust Valve Expansion Valve Absorber Evaporation pump NH3-H2O Q2 Cooling Water Q3 6.8 Absorption Refrigeration System Principle NH3 Weak Rich NH3

  50. 6.8 Absorption Refrigeration System Thermodynamic Analysis Thermal Efficiency Advantage: A liquid is compressed instead of a vapor , and thus the work input for absorption refrigeration system is very small.

More Related