1 / 16

ECE 445: Printing Press

ECE 445: Printing Press. Jerome Han John Doherty Adriana Siu TA: Kieran Levin Profesor: Scott Carney. Introduction and Objectives. Overview. Benefits and Features. Mechanical Setup The film system The print system External control panel Ultrasonic sensors.

tilly
Download Presentation

ECE 445: Printing Press

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. ECE 445: Printing Press Jerome Han John Doherty Adriana Siu TA: Kieran Levin Profesor: Scott Carney

  2. Introduction and Objectives Overview Benefits and Features • Mechanical Setup • The film system • The print system • External control panel • Ultrasonic sensors • Automation of all mechanical procedure (saves labor cost and time) • More cost effective controller • Easy user interface • Programmable

  3. Original Design

  4. Content: Mechanical Build • Unwind Roller • *1st set for tension/distance(2 rollers) • Printing (3 rollers) • Rewind Roller • 4 sensor mounts • 2 bottom • *2 sides

  5. Velocity and Position Controlled Motors Schematic

  6. Content: “Velocity Controlled Motor” • Analog Voltage Reference α Speed • Pn300=12V/rated speed (12V=3000RPM, 6V=1500RPM) • Microcontroller outputs PWM at f=490Hz • PWM=>RC LP Filter=>Analog Voltage • *Relation: Duty Cycle of PWM vs. RPM:

  7. Content: “Position Controlled Motor” • Pulse Train Reference α • Speed of motor (frequency of pulses) & • distance traveled by motor shaft (number of pulses) • Time b/w pulse trains α • Delay b/w distance traveled • Reference units:

  8. Control Panel

  9. Control Panel Modes

  10. Content: Front Panel • On-Off switch -Turn on and off the motors and disables the control panel • Potentiometer -Controls the speed of the velocity motor with in a jog mode • Matrix Keypad -Changes the presets of the motors • LEDs -Indicates the status of the motors • Further Tests • Switch

  11. Content: Ultrasonic Sensors Theory • Sends ultrasonic waves to object and receives reflected waves for detection • Use 1 digital pin for trigger output/echo input • Operating Frequency of 40 kHz • Theoretical Minimum and Maximum range from 3cm to 4m

  12. Content: Ultrasonic Sensors: Experimental Results

  13. Content: Ultrasonic Sensors: Experimental Results

  14. Content: Ultrasonic Sensors: Discussion and Tolerance • Sources of Error • Data acquisition from oscilloscope • Measurement of width from oscilloscope • Inconsistency in object detection • Placement in mechanical setup • Improvement • Tolerance Analysis

  15. Recommendations and Conclusion: Design Improvement • Motors • Balance velocity voltage output (*D/A converter, tension control) • Mechanical: More distance for no crinkle in paper • Front Panel • LCD screen • Sensors • Mechanical: Side placements too low • Printing Press worked! • Different speeds and distance b/w prints

  16. Ethical Concerns • Hardware malfunctions • Could hurt somebody (ink in their eyes) • Getting their hand caught in the rollers if the ultrasonic sensors malfunction and don’t detect hand • SRf05 low cost so they can get damaged easily • Control panel buttons are very small and this might confuse the operator (no red for stop or green for go buttons)

More Related