1 / 2

LED Light Kit

This is the LED Light Kit for current MTX carriers<br>Have a Look: - https://www.mototote.com/documents/Instructions_MTLE.pdf<br>

Mototote
Download Presentation

LED Light Kit

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. Revised 03-19-2019 MotoTote is a registered trademark of MotoTote LLC Copyright 2019 MotoTote LLC All rights reserved In Australia patrick@nicerack.com.au support@mototote.com or in the US call 888-333-4621 If you need assistance please contact us at The Easiest way to haul your Bike. INSTRUCTIONS LED TAIL LIGHT KIT In the Box: Light kit assembly 4 mounting screws Black nylon ties Australian version has 7-pin plug and amber turn signals You will need: Flathead and philips head screwdrivers Scissors or knife to cut nylon ties If you purchased your MotoTote before April 2014 you will also need a drill with a 5/32” or 4mm bit

  2. 1 2 SEPARATE FROM BEZEL ATTACH BEZELS Separate light from bezel (base) with a flat head screwdriver as shown leaving the cable running through bezel. IDENTIFY left/right light by labels on back. Attach bezel to MTX Platform tube with screws provided and pre-punched holes. NOTE: If you bought your MotoTote before April 2014 you will need to drill two more holes in the MTX Plat- form tube (one for each light). First drive screw in outer hole as shown in step 2 above, then use bezel as guide to drill the additional inboard hole. 3 4 SECURE cables PRESS INTO BEZEL Press light into bezel with palm of hand as shown until it “snaps” into place. Run the cables along the underside of the MotoTote toward center then forward to- ward vehicle. Secure with the nylon ties. 5 connect and check Australian connector Check for proper operation of brake, turn signal, and tail lights. Apply brakes and use turn signals with the headlights on. Repeat with the headlights off (tail lights will be off but brake and turn signals should work). Plug into vehicle connector and check for proper operation as described at right.

More Related