1 / 14

STRESS and STRAIN ASPECTS OF ROCK

Part 2. STRESS and STRAIN ASPECTS OF ROCK. Unlike soils, pure rock (solid material between joints) is an elasto-plastic material , subject to elastic recovery AND permanent deformation, as shown in this Stress vs strain plot.

inari
Download Presentation

STRESS and STRAIN ASPECTS OF ROCK

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. Part 2 STRESSand STRAINASPECTS OF ROCK

  2. Unlike soils, pure rock (solid material between joints) is an elasto-plastic material, subject to elastic recovery AND permanent deformation, as shown in this Stress vs strain plot.

  3. Physical phenomena associated with uniaxial compression tests of rock cylinders, under near zero confinement.

  4. Unconfined compression tests on rock cylinders generally exhibit significant propagation of extension cracks after peak strength is exceeded, followed by friction and interlocking between cracked sections of the sample.

  5. Example of a full-range stress-strain plot, showing how post-failure stiffness is estimated

  6. Physical phenomena associated with gradual breakdown of rock cylinders on the post-failure side of a stress-strain plot

  7. The stress strain behavior of a natural rock like sandstone is a combination of its mineralogical components, in this case: quartz and calcite

  8. Most rocks exhibit increasingly plastic behavior with increasing levels of confinement, as shown in this series of jacketed triaxial tests on a marble. So, the most brittle behavior is typically exhibited under conditions of the least confinement, at the Earth’s surface.

  9. Elasticdeformation Plastic deformation • Elasto-plastic behavior of Solenhofen Limestone, as seen in measured relaxation in percent axial strain after triaxial compression under significant lateral confinement

  10. The most common physical attributes of laboratory tests on intact rock are portrayed here. The true elastic modulus can only be determined by employing load cycles.

  11. Goodman’s concept of Modulus of Permanent Deformation, M, was introduced in 1980. It is important to appreciate in porous rocks which often exhibit “permanent set” with each loading cycle, such as sandstone.

  12. Mohr Circles are the most common technique used to describe the failure envelope and the strength parametersfriction and cohesion Rock tends to exhibit a slightly curvalinear failure envelope with low tensile strength, shown at upper right

  13. Be careful when evaluating elastic modulus values. The terms used connote different kinds of calculations, as shown here.

  14. The elastic modulus (E) varies with the stress level and the induced strain

More Related