1 / 19

Lecture 18: Bipolar Single Stage Amplifiers

Lecture 18: Bipolar Single Stage Amplifiers. Prof. Niknejad. Lecture Outline. BJT Amps BJT Biasing Common Emitter Amp Common Base Amp Common Collector Amp AKA Emitter Follower β Multiplier Concept Emitter Degeneration. Bipolar Amplifiers. Common-emitter amplifier: .

liza
Download Presentation

Lecture 18: Bipolar Single Stage Amplifiers

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. Lecture 18:Bipolar Single Stage Amplifiers Prof. Niknejad

  2. Lecture Outline • BJT Amps • BJT Biasing • Common Emitter Amp • Common Base Amp • Common Collector Amp • AKA Emitter Follower • β Multiplier Concept • Emitter Degeneration University of California, Berkeley

  3. Bipolar Amplifiers Common-emitter amplifier: Biasing: adjust VBIAS= VBE sothat IC = ISUP. University of California, Berkeley

  4. Small-Signal Two-Port Model Parameters: (IC = 1 mA, β =100, VA = 3V) University of California, Berkeley

  5. Common-Base Amplifier To find IBIAS, note that IBIAS = IE = - (1/F)IC Common-base current gain Ai = - F University of California, Berkeley

  6. CB Input Resistance Summing currents at the input node: small University of California, Berkeley

  7. CB Output Resistance put rocback in after finding vt / it note polarity Same topology as CG amplifier, but with r || RS rather than RS University of California, Berkeley

  8. Output Impedance Details • First draw small signal equivalent circuit with transistor and simplify as much as possible • Then (if needed) add the small signal equivalent circuit • If frequency is low, get rid of caps! University of California, Berkeley

  9. Output Impedance Calculation University of California, Berkeley

  10. Common-Base Two-Port Model Why did we consider it a current amp? • Current Amp : • Unity Current Gain (-1) • Small Input Impedance • Large (huge!) Output Impedance University of California, Berkeley

  11. Common-Collector Amplifier DC Bias: output is one “VBE drop” down from input “Emitter Follower” University of California, Berkeley

  12. Common-Collector Input Resistance University of California, Berkeley

  13. Common-Collector Output Resistance Divider between vt and v : University of California, Berkeley

  14. Common-Collector Output Res. (cont) • Looking into base of emitter follower: load impedance larger by factor β+1 • Looking into emitter of follower: “source” impedance smaller by factor β+1 University of California, Berkeley

  15. Common-Collector Voltage Gain KCL at the output node: note v = vt- vout University of California, Berkeley

  16. Common-Collector Two-Port Model typo: RL • Voltage Amp : • Unity Voltage Gain (+1) • Large Input Impedance • Small Output Impedance University of California, Berkeley

  17. Summary of Two-Port Parameters University of California, Berkeley

  18. Typical “Discrete” Biasing • A good biasing scheme must be relatively insensitive to transistor parameters (vary with process and temperature) • In this scheme, the base current is given by: • The emitter current: University of California, Berkeley

  19. Gain for “Discrete” Design • Let’s derive it by intuition • Input impedance can be made large enough by design • Device acts like follower, emitter=base • This signal generates a collector current Can be made large to couple All of source to input (even with RS) University of California, Berkeley

More Related