1 / 11

F. Garnier, P-A. Giudici, F.Bergsma CERN MICE Collaboration Meeting No. 28

Magnet Measurement Device for MICE. F. Garnier, P-A. Giudici, F.Bergsma CERN MICE Collaboration Meeting No. 28 Absorber Systems & MICE Magnets Session 6 October 2010 technical drawings by O.Jamet. Layout. Rails. Trolley with B-sensors. Servo motor with encoder. ¼ pipe of aluminum.

lotta
Download Presentation

F. Garnier, P-A. Giudici, F.Bergsma CERN MICE Collaboration Meeting No. 28

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. Magnet Measurement Device for MICE F. Garnier, P-A. Giudici, F.Bergsma CERN MICE Collaboration Meeting No. 28 Absorber Systems & MICE Magnets Session6 October 2010 technical drawings by O.Jamet

  2. Layout Rails Trolley with B-sensors Servo motor with encoder ¼ pipe of aluminum Cradles Tooth belt Support by adjustment screws on cradles Magnet bore Support by tripods

  3. Disk with 7 B-sensors calibrated at 4.5 Tesla Axis of rotation 5 degree steps Magnet bore Rails ¼ pipe of aluminum Cradle 5 m

  4. 2 versions Extension disk for AFC 5m version for spectrometer solenoids 2m version for focus absorber solenoids. Extension disk to by-pass internal flange AFC Need to measure from both sides 2m version could be used to measure eventually coupling coils Irremovable flange

  5. Single-row 10 pin connector Feet tolerance 50 µm thermistor Homogeneous field region is small => need high density => single row connector Glass cube with 3 Hall probes B-sensor card Stack of B-sensors in calibrator Double row flat- cable connector SPI-interface front back Passive backplane for B-sensor to carry double-row connector Daisy chain B-sensors

  6. Calibration done at GHMFL Grenoble Bmax=4.5 Tesla 130 mm IMMW15 F.Bergsma

  7. Mounting of B-sensors

  8. Measurement grid Disk can rotate in steps of 5 degree 180 mm sensor has to be removed for this region

  9. DAQ + control SPI -> RS232 interface, SPI-bus with 7 slots Where to put interface: inside or outside 4 Tesla? Leave both options open DAQ program (MSVC) runs on PC (laptop) BALDOR servo engine with NextMove ESB motion controller ESB connected with CANbus to PC

  10. STRATEGY mechanics: 1 build 5 m version , test precision 2 if precision insufficient add encoder, foresee laser tracker during measurements 3 build 2 m version DAQ: Build simple read-out for 7 B-sensors Anticipate to have interface outside high field region Accuracy: Better than 0.5 mm longitudinal +/- 0.1mm radial +/- 1 mrad directive Bx,By,Bz +/- 2 mT Check in situ with NMR Surveying done at CERN with laser tracker

More Related