1 / 12

A Proposed Layout for Light-Sealing around the Focal Plane

A Proposed Layout for Light-Sealing around the Focal Plane. Robert Besuner 17 April 2005. Some notes. Desire is to replace two or three labyrinths with one. Labyrinths replaced: cone/OTA, cone/FP, maybe FP/aft of FP. Replace those with one light seal from radiator to OTA.

Download Presentation

A Proposed Layout for Light-Sealing around the Focal Plane

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. A Proposed Layout for Light-Sealing around the Focal Plane Robert Besuner 17 April 2005

  2. Some notes • Desire is to replace two or three labyrinths with one. • Labyrinths replaced: cone/OTA, cone/FP, maybe FP/aft of FP. • Replace those with one light seal from radiator to OTA. • Could substitute word ‘labyrinth’ with ‘bellows’ or anything light-tight with minimal thermal and mechanical coupling between the two sides. • Relative motions between radiator and OTA in vibe may be large...labyrinth clearances here are 20mm. • Thermal coupling across labyrinth could be sizeable. One possibility is to make light seal thermally insulation. If G-10 fiberglass, something like a watt might flow from OTA to radiator (That’s pure conduction, no rad. analysis at labyrinth).

  3. Fully assembled

  4. light seal cover removed

  5. fp light seal being withdrawn

  6. light seal turned to view labyrinth

  7. fp, cone installed

  8. fp being removed, should use GSE to support bipods

  9. fp removed, cone still installed

  10. cone being withdrawn, note mounting ring that stays with bipods, which stay with bench

  11. cone and fp removed, the cone’s ring and bipods stay

  12. section showing possible heat strap paths • violet-straight to cover, heat flows from cover to rest of radiator • blue-straight to (conducting) light seal, heat flows to main radiator and cover • green-thru light seal (thru labyrinth?, thru more strap terminations?), then to radiator • Also, note gap between cone and cold plate...no labyrinth

More Related