1 / 48

Hearing Conservation

Hearing Conservation. Prevention of Occupationally Induced Hearing Loss. NSTC-09. Introduction. Introductions. Name Company and/or Position Experience related to working areas with high noise levels. Administration and Safety. Emergency Procedures Restrooms/Breaks/Smoking Safety Minute.

midori
Download Presentation

Hearing Conservation

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. Hearing Conservation • Prevention of Occupationally Induced Hearing Loss NSTC-09

  2. Introduction

  3. Introductions • Name • Company and/or Position • Experience related to working areas with high noise levels

  4. Administration and Safety • Emergency Procedures • Restrooms/Breaks/Smoking • Safety Minute

  5. Goal • To introduce employees to the potential hazards and the control measures for working safely in areas where noise levels can contribute to hearing loss.

  6. Objectives • Explain the health effects of excessive noise in the workplace • Explain the control measures that can be taken to reduce workplace noise and prevent noise-induced hearing loss • Demonstrate the proper selection, fitting, use, and care of hearing protection devices

  7. Objectives • Identify and describe the components of a Hearing Conservation Program • State the purpose of baseline audiometric evaluations • Discuss personal compliance in hearing conservation and noise control practices

  8. Why Noise is a Hazard

  9. Those Affected by Noise • The National Institute on Deafness and Other Communication Disorders (NIDCD) estimates 26 million Americans between the ages of 20-69 have high frequency hearing loss from excessive noise at work or in leisure activities. • Noise is a common health hazard at industrial sites on the North Slope of Alaska (BP ASH, p. 22).

  10. What is NOISE? • Noise is a physical energy that moves through air as sound waves. • Its frequency (pitch) is measured in cycles/second or hertz (Hz). • Its intensity (loudness or sound pressure) is measured in decibels (dBA). • Its duration or the length of exposure is classified as continuous, intermittent, or impact noise. Pressure Hazard, BP ASH, page 127

  11. Noise TWA • Noise is measured as a time weighted average (TWA). • It is a daily “dose” of noise during the period of time that an employee is working in an area. • The TWA is determined by: • how loud the equipment is (intensity). • how close the employee is to the noise. • how long the employee is exposed to the noise (duration). ASH, page 16; BP ASH, pages 22, 41

  12. OSHA Noise Standard • Action Level: An 8 hr. TWA of 85 dBA requires employers to implement a Hearing Conservation Program. • Ceiling or PEL: An 8 hr. TWA of 90 dBA requires employers to implement engineering controls, administrative controls, and personal protective equipment to lower the noise exposure levels. 29 CFR 1910.95 (a) – (c )

  13. North Slope Noise Standard • Action Level: A 12 hr. TWA of 82 dBA requires North Slope employers to implement a Hearing Conservation Program including the use of hearing protection. • Noise levels of 100 dBA or more require the use of double hearing protection (earplugs and earmuffs) and limited exposure. • Signs are posted in production facilities to warn against noise hazards and to indicate the level of hearing protection required. ASH,page 16; BP ASH, page 22

  14. Recreational Noise Levels

  15. Workplace Noise Levels

  16. Noise-Induced Hearing Loss (NIHL)

  17. Anatomy of the Ear • The ear has three (3) basic regions • The Outer Ear • The Middle Ear • The Inner Ear

  18. How We Hear • Sound waves create pressure variations that cause the eardrum to vibrate. • Bones in the middle ear transmit vibrations to the cochlea. • Receptors (hair cells) in the cochlea convert vibrations to electrical energy.

  19. How We Hear • The brain interprets electrical impulses as sound. • Nerve cells in cochlea are tuned to specific frequencies. • Base of cochlea: sensitive to high frequencies • Tip of cochlea: sensitive to low frequencies

  20. How NIHL Occurs • NIHL is unnoticeable in its earliest stages. • NIHL accumulates with each over-exposure because excessive noise damages the receptors (auditory hair cells). • NIHL increases with the reduction in the number of functioning receptors. • NIHL is permanent, but 100% preventable.

  21. Normal Cochlea Auditory receptors line the inside of the cochlea

  22. Damaged Cochlea Damaged auditory receptors Normal auditory receptors

  23. Types of Hearing Loss • Tinnitus: a permanent ringing in the ears • Temporary Threshold Shifts (TTS): Hearing returns to normal after noise exposure • Permanent Threshold Shifts (PTS): Repeated noise exposure without a return to normal • Standard Threshold Shifts (STS): A change in hearing threshold of more than 10 dBA average loss in 2000, 3000, or 4000 Hz in either ear • Presbycusis: hearing loss due to aging and repeated long-term environmental noise

  24. Other Harmful Effects from Noise Exposure • Increased fatigue • Headaches • Muscular tension • Increased heart rate and blood pressure • Impaired balance • Decrease in work productivity

  25. Noise Control Measures

  26. Noise Control Measures NIHL is preventable if the proper control measures are implemented. • Engineering Controls: Remove, reduce, mitigate or isolate the hazard • Administrative Controls: Reduce the hazard while the worker is exposed • Personal Protective Equipment: Wear hearing protection devices

  27. Engineering Controls • Erect acoustical enclosures and barriers around noisy equipment. • Move noise sources away from reflective surfaces (concrete or brick walls, corners). • Retrofit (install mufflers, silencers) and maintain (replace worn parts, lubricate, balance) older equipment which gets noisier over time. • Install sound dampening material and/or devices on equipment and tools.

  28. Administrative Controls • Put distance between the noise source and workers. • Limit the amount of time workers are exposed to the noise (job rotation, frequent breaks, scheduling equipment operating times). • Limit the number of workers allowed in an area with excessive noise. • Provide worker training in hazard recognition and methods of protection. • Provide warning signs. BP ASH, page 141; ASH, page 16

  29. Hearing Protection Devices Earmuffs Foam (Disposable) Earplugs Molded (Reusable) Earplugs

  30. Hearing Conservation Program

  31. Action Levels • OSHA requires employers to administer a hearing conservation program whenever employee noise exposure levels equal or exceed the action level of an 8-hour TWA of 85 dBA). • The action level on the North Slope, as stated in the Alaska Safety Handbooks, is when noise exposures exceed a 12-hour TWA of 82 dBA . 29 CFR 1910.95 (c ); ASH, page 16; BP ASH, page 22

  32. Components of a Hearing Conservation Program • Noise Monitoring at Worksite (Hazard Assessment) • Controlling Excessive Noise • Employee Notification and Training • Audiometric Testing • Hearing Protection Device Distribution • Program Record Keeping 29 CFR 1910.95 (c ) – (o)

  33. Audiometric Testing Program • An evaluation to measure an individual’s ability to hear • Performed by a licensed or certified audiologist or other physician • Establishes a baseline for the annual hearing profile that will indicate if there is a threshold shift in subsequent years 29 CRF 1910.95 (g)

  34. Training Requirements • Effects of noise on hearing • Purpose of hearing protection, types of devices and the advantages and disadvantages of each • Proper selection, fitting, and use of hearing protection devices • Purpose of audiometric testing and an explanation of test procedures • Refresher training required annually 29 CRF 1910.95 (k)

  35. Employer Responsibility • Must protect workers exposed to hazardous noise levels that exceed the Permissible Exposure Limit (PEL) • Must ensure that engineering and administrative controls are followed and hearing protection is provided and used with training • Must have a Hearing Conservation Program whenever noise levels equal or exceed the action level of 85 dBA for an 8 hr. TWA 29 CFR 1910.95 (c ) – (o)

  36. Employee Responsibility • Must follow administrative controls established to reduce or eliminate noise exposure • Reduced work shifts or job rotations • Avoidance of high noise areas • Must wear hearing protection when exposed to high noise levels on the North Slope • < 82dBA– no protection necessary * • 82-99dBA– protection necessary * • >100dBA– double protection necessary * * Time Weighted Average over a 12 hr. shift ASH, page 16; BP ASH, pages 22, 41

  37. Proper Fitting of Hearing Protection

  38. Fitting Guidelines • Earplugs come in a variety of sizes because no one earplug fits all ear canals. • Correct fit is essential, so find the right size. • Employers may provide fit testing. • Maximum protection occurs when the earplug provides an airtight seal in the ear canal or against the side of the head. • User needs to check and adjust earplugs throughout the day.

  39. Fitting Foam Earplugs (Disposable) • Be sure your hands are clean. • Roll the earplug into a crease-free cylinder. • Pull back the ear by reaching over the head with your free hand and gently pull the top of the ear up and out. • Insert earplug well into ear canal and hold until it fully expands. • If properly fitted, the end of the earplug should not extend beyond the flap (tragus) of the ear canal.

  40. Proper Fitting of Earplugs • Reach over your head with the opposite hand and pull the top of the ear outward to open the ear canal.

  41. Proper Fitting of Earplugs • While holding the ear open, insert the earplug into the ear canal.

  42. Visual Check for Properly Fitted Earplugs • The earplug should fit inside the ear without protruding past the ear flap (tragus).

  43. Fitting Molded Earplugs (Reusable) • Be sure your hands are clean before inserting the earplug. • Reach over head with free hand, pull top of ear up and back. • Insert earplug so all flanges are well inside the ear canal. • If properly fitted, only the stem of the earplug should be visible to someone looking at you from the front.

  44. Fitting Earmuffs • Place ear cups over each ear and adjust the headband by sliding it up or down at the attachment buttons. • The ear cushions should seal firmly against the head. • For best results, remove all hair from underneath the ear cup. • Make sure the ear cup creates a seal and completely covers the ear. • Temple bars on safety glasses will break the protective seal.

  45. Care and Maintenance

  46. Care and Maintenance of Earplugs • Dispose of single use earplugs daily. • Inspect reusable earplugs for dirt, cracks or hardness and replace if damaged. • Clean reusable earplugs with mild soap and water, as appropriate, and dry thoroughly.

  47. Care and Maintenance of Earmuffs • Clean ear cushions and headband regularly with mild soap and water. • Replace ear cushions and foam inserts every 6 months with normal wear and more often with heavy use or under humid/extreme conditions.

  48. Summary • Noise is a common health hazard on the North Slope. • The action level on the North Slope is 82 dBA for a TWA of 12 hours which requires participating in the Hearing Conservation Program and the wearing of hearing protection. • Proper selection and fitting of hearing protection devices is the key to preventing NIHL. • Hearing loss is preventable. ASH, page 16; BP ASH, pages 22, 41

More Related