1 / 7

Oscilloscope Probe Selection and Considerations

Oscilloscope Probe Selection and Considerations . Lynsey Metz 12/10/13 EECS 713. Goal. Exploration of active versus passive oscilloscope probes and factors contributing to inaccurate measurements. Driving Factors: Probe capabilities Preserving measurement integrity Cost . Motivation.

prentice
Download Presentation

Oscilloscope Probe Selection and Considerations

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. Oscilloscope Probe Selection and Considerations Lynsey Metz 12/10/13 EECS 713

  2. Goal Exploration of active versus passive oscilloscope probes and factors contributing to inaccurate measurements. Driving Factors: • Probe capabilities • Preserving measurement integrity • Cost

  3. Motivation • Probes will interact with the circuit being tested, affecting the measurement • Rise time • Circuit loading • Inductance from ground lead • Reduced impedance at high frequency due to capacitance • Passive probe • Active probe with amplifier

  4. Specs • Passive • Good up to 500 MHz • Cost ranges from fifteen to a few hundred dollars • Active

  5. Test • Ideally, collect measurements from one high-frequency device using an active, passive, and shop-built 21:1 probe and compare results and verify active probe performance matched datasheet specs. • The shop-built 21:1 probe consists of a length of coaxial cable, a leaded 1k resistor, and some short ground lead. • No active probe available. Used a coaxial cable terminated in SMA and BNC connectors. • The device used for testing was a 150 MHz oscillator

  6. Results (A) Coaxial cable (B) Passive probes (C) Shop-built Probe

  7. References • Allen, C. (2013, Nov 19). HSD Test & Measurement, EECS 713, University of Kansas, Lawrence, KS. • Johnson. (1993). High speed digital design: A handbook of black magic. Pearson Education. • Change, Jae-yong,. 6 Hints for Better Scope Probing. Agilent Technologies.

More Related