1 / 8

The Improved Howland Current Pump

The Improved Howland Current Pump. By Tim Green – PA- Linear Applications Engineering Manager. V-I Improved Howland Current Pump. Given: PPSL (Preferred Parts Selection List) Parts: OPA569 Power Op Amp. Design Goal: Vcc =+5V Vin = 0V to 500mV  Iout = 0 to 500mA

Download Presentation

The Improved Howland Current Pump

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. The Improved Howland Current Pump By Tim Green – PA- Linear Applications Engineering Manager

  2. V-I Improved Howland Current Pump Given: PPSL (Preferred Parts Selection List) Parts: OPA569 Power Op Amp Design Goal: Vcc =+5V Vin = 0V to 500mV  Iout = 0 to 500mA Rload = 8 ohms, Grounded Load 1% FSR accuracy in transfer function (Iout/Vin) Design Considerations: Need to Sense current in High Side Need to drive high current -> Power Op Amp? Need RRO Op Amp, Input CM to Ground Design Preliminary Analysis: If there is voltage headroom then: Power Op Amp offers single IC solution Low drop across sense resistor -> maximize headroom & minimize power dissipation

  3. V-I Improved Howland Current Pump Ideal Op Amp RT0 can be used to increase the effective output impedance of the Current Source BUT care must be taken to always ensure more feedback to the –input of the op amp than to the +input of the op amp as net positive feedback = INSTABILITY !!

  4. V-I Improved Howland Current Pump Set RX=RF and RZ=RI and move all tolerances to worst case for accuracy analysis 1% Resistors (w/RT=0) could yield 9% Accuracy at T=25°C 0.1% Resistors (w/RT=0) could yield 0.9% Accuracy at T=25°C Still useful for V-I control in Motors, Valves, TECs, LEDs, etc Other system feedback re-adjusts VM or VP for final results

  5. V-I Improved Howland Current Pump Set RX=RF and RZ=RI Input Voltage is Gained up and Differentially forced across RS

  6. V-I Improved Howland Current Pump: Vin = 500mV, Iout = 500mA Always Check Loop Gain & Compensate for Stability

  7. V-I Improved Howland Current Pump: Vin = 0V, Iout = 0A Always Check Loop Gain & Compensate for Stability

  8. V-I Improved Howland Current Pump : Vin = 0V, Iout = 0A (modified) Add Ros to force Vm > 2mV (worst case Vos) to drive Voa as low as possible when Vin = 0V Always Check Loop Gain & Compensate for Stability

More Related