1 / 6

NAC source -- data from UT2014-04-25-00:00

PHASECAM – April 25 th status. NAC source -- data from UT2014-04-25-00:00. OPD-tip/tilt correlation. Tip -tilt. OPD. OPD-tip/tilt correlation. Tip-tilt not symmetric?. CG and phase loop blending. CG measurement too noisy at 1kHz: .

sharne
Download Presentation

NAC source -- data from UT2014-04-25-00:00

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. PHASECAM – April 25th status NAC source -- data from UT2014-04-25-00:00

  2. OPD-tip/tilt correlation Tip-tilt OPD

  3. OPD-tip/tilt correlation Tip-tilt not symmetric?

  4. CG and phase loop blending • CG measurement too noisy at 1kHz: -2.2 mm White fringe + 2.2 mm

  5. CG and phase loop blending • Phase actually stays within one cycle:

  6. CG and phase loop blending • => Averaging CG over 20 frames so that the histograms don’t overlap; • Define minimum CG error for one fringe jump (depends on phase setpoint!). • Tested successfully with our vibration simulator: • Merging tests under progress. Tricky because phase setpoint and CG setpoint correlated. Approach: • Run continuous averaging of CG. If CG > CGmin, send 2 mm or CG error and wait for CG to be ok (at 50Hz). Unstable so far… • Blend the two by weighting the CG correction and phase correction. Cannot use the CG error as weight because it cannot be trusted at 1kHz.

More Related