1 / 6

MAE 5310: COMBUSTION FUNDAMENTALS

MAE 5310: COMBUSTION FUNDAMENTALS. Chemical Time Scales and Partial Equilibrium October 3, 2012 Mechanical and Aerospace Engineering Department Florida Institute of Technology D. R. Kirk. Insight gained from knowledge of chemical time scale, t chem

simeon
Download Presentation

MAE 5310: COMBUSTION FUNDAMENTALS

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. MAE 5310: COMBUSTION FUNDAMENTALS Chemical Time Scales and Partial Equilibrium October 3, 2012 Mechanical and Aerospace Engineering Department Florida Institute of Technology D. R. Kirk

  2. Insight gained from knowledge of chemical time scale, tchem What is approximate magnitude of time scale? Characteristic time is defined as time required for concentration of A to fall from its initial value to a value equal to 1/e times the initial value [A](t=tchem)/[A]0=1/e RC circuit analog CHEMICAL TIME SCALES Unimolecular reactions Bimolecular reactions Bimolecular reactions case where [B]0 >> [A]0 Termolecular reactions Termolecular reactions case where [B]0 >> [A]0

  3. EXAMPLE: CHEMICAL TIME SCALE CALCULATIONS 1 • Reaction 1 is an important step in oxidation of CH4 • Reaction 2 is key step in CO oxidation • Reaction 3 is a rate-limiting step in prompt-NO mechanism • Reaction 4 is a typical radical recombination reaction • Estimate tchem associated with least abundant reactant in each reaction for following 2 conditions • Assume that each of 4 reactions is uncoupled from all others and that third-body collision partner concentration is the sum of the N2 and H2O concentrations) k=1.0x108T1.6exp(-1570/T) k=4.76x107T1.23exp(-35.2/T) k=2.86x108T1.1exp(-10,267/T) k=2.2x1022T-2.0 2 3 4 Condition II: High Temperature T=2199 K, P=1 atm cCH4=3.773x10-6 cN2=0.7077 cCO=1.106x10-2 cOH=3.678x10-3 cH=6.634x10-4 cCH=9.148x10-9 cH2O=0.1815 Condition I: Low Temperature T=1344 K, P=1 atm cCH4=2.012x10-4 cN2=0.7125 cCO=4.083x10-3 cOH=1.818x10-4 cH=1.418x10-4 cCH=2.082x10-9 cH2O=0.1864

  4. EXAMPLE SOLUTION • Increasing T shortens chemical time scales for all species, but most dramatically for CH4 + OH and CH + N2 reactions • For the CH4 + OH reaction, the dominant factor is the decrease in the given CH4 concentration • For the CH + N2 reaction, the large increase in the rate coefficient dominates • Characteristic times at either condition vary widely among the various reactions • Notice long characteristic times associated with recombination reaction H + OH + M → H2O + M, compared with the bimolecular reactions. • That recombination reactions are relatively slow plays a key role in using partial equilibrium assumptions to simplify complex chemical mechanisms (see next slide) • Note that tchem=1/[B]0kbimolec could have been used with good accuracy for reaction 3 at both low and high temperature conditions, as well as reaction 1 at high temperature because in these cases one of reactants was much more abundant than other

  5. PARTIAL EQUILIBRIUM • Many combustion process simultaneously involve both fast and slow reactions such that the fast reactions are rapid in both the forward and reverse directions • These fast reactions are usually chain-propagating or chain-branching steps • The slow reactions are usually the termolecular recombination reactions • Treating fast reactions as if they were equilibrated simplifies chemical kinetics by eliminating need to write rate equations for radical species involved, which is called the partial-equilibrium approximation • Consider the following hypothetical mechanism:

  6. PARTIAL EQUILIBRIUM VS. STEADY-STATE • Net result of invoking either partial equilibrium assumption or steady-state approximation is the same: • A radical concentration is determined by an algebraic equation rather than through the integration of an ordinary differential equation • Keep in mind that physically the two approximations are quite different: • Partial equilibrium approximation forcing a reaction, or sets of reactions, to be essentially equilibrated • Steady-state approximation forces the individual net production rate of one or more species to be essentially zero • There are many examples in combustion literature where partial equilibrium approximation is invoked to simplify a problem • Examples: • Calculation of CO concentrations during the expansion stroke of a spark-ignition engine • Calculation of NO emissions in turbulent jet flames • In both examples, slow recombination reactions cause radical concentrations to build up to levels in excess of their values for full equilibrium

More Related