1 / 8

Steel Connecting Rods

Steel Connecting Rods. Factory connecting rods are mass produced Cast from regular automotive grade Iron. Reasons: Faster Easier Cheaper. Background. Background Continued. I-Beam design reinforces wrong face 4 stroke engine revolution places: Moment load Compression load Tension load.

trina
Download Presentation

Steel Connecting Rods

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. Steel Connecting Rods

  2. Factory connecting rods are mass produced Cast from regular automotive grade Iron Reasons: Faster Easier Cheaper Background

  3. Background Continued • I-Beam design reinforces wrong face • 4 stroke engine revolution places: • Moment load • Compression load • Tension load

  4. When Regular Rods Go Bad • Factory Rods are usually the weak link

  5. New Design, New Material • AISI 4340 Steel is the most common • Other Materials also used: • Titanium • 7075 T-6 Aluminum • Nodular Iron • Pearlite Iron • 5140 Steel • New H-Beam design places reinforcement on the proper face

  6. H-Beam Design • Designed on AutoCAD for low weight, high strength • 800 HP and 7,500 Rpm Rating (for Pontiac) • Rods and Caps are forged separately • Optimizes grain flow • Enhances structural Integrity • Higher Quality control than factory

  7. Specifications of AISI 4340 Steel • Density: 7.85 g/cm3 • Tensile Strength (Ultimate): 1220 MPa • Tensile Strength (Yield): 786 MPa • Percent Elongation at Break: 13.5% • Percent Reduction of Area: 37.3% • Modulus of Elasticity: 205 GPa • Poisson’s Ratio: 0.29 • Machinability: 50% • Shear Modulus: 80 GPa All Specifications are for AISI 4340 Steel, normalized, 50 mm round

  8. Any Questions?

More Related