1 / 15

Stave Irradiation

Stave Irradiation. See setup on next page Before irradiation IR imaging done with water coolant at 20.6 0 C, flow rate of 1 liter/min, 7.1 W/module First irradiation Stave in vessel with nitrogen atmosphere. Module #1(M1) end closest to source Stave in vertical position in ring source

vinny
Download Presentation

Stave Irradiation

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. Stave Irradiation • See setup on next page • Before irradiation • IR imaging done with water coolant at 20.60C, flow rate of 1 liter/min, 7.1 W/module • First irradiation • Stave in vessel with nitrogen atmosphere. • Module #1(M1) end closest to source • Stave in vertical position in ring source • Maximum dose is 50 Mrad but varies along stave - how much is TBD. • IR imaging done with water coolant at 20.80C, 1 liter/min, 7.1 W/module • Before and after images follow • Paint quality varies(some bubbles). This affects thermography. • Room temperature can vary by up to 2C, which affects measurement • Error on comparison measurement around 2C(guess)

  2. Outlet Inlet 13 1 Stave and Holder

  3. Module 1 - Before Module 2 - Before Module 1 - After Module 2 - After

  4. Module 3 - Before Module 4 - Before Module 3 - After Module 4 - After

  5. Module 5 - Before Module 6 - Before Module 5 - After Module 6 - After

  6. Module 7 - Before • Conclusions after first irradiation • Max temperature rise is <40C comparing hottest points • Size of warmer regions increases after irradiation • There is already large spread in temperature on module before irradiation.. Module 7 - After

  7. Thermography After 2nd Irradiation • Modules 7-13 only • Operating conditions • Water temperature 20.7C • Water flow 1.02 l/min • Power per module about 7.00.1W • Other modules are masked off except one viewed. • In the next pages, three thermograms are shown - original(before any irradiation), after 1st irradiation, after 2nd irradiation. • Order is shown on next page

  8. Before Irradiation After 1st irradiation After 2nd irradiation

  9. Module 7

  10. Module 8

  11. Module 9

  12. Module 10

  13. Module 11

  14. Module 12

  15. Module 13

More Related