1 / 24

A 2-GHz Direct Sampling ΔΣ Tunable Receiver with 40-GHz Sampling Clock and on-chip PLL

A 2-GHz Direct Sampling ΔΣ Tunable Receiver with 40-GHz Sampling Clock and on-chip PLL. T. Chalvatzis 1 , T. O. Dickson 1,2 and S. P. Voinigescu 1 1 University of Toronto, Toronto, CA 2 now with IBM T.J. Watson Research Center, NY, USA. Outline of Presentation. Motivation Circuit design

Download Presentation

A 2-GHz Direct Sampling ΔΣ Tunable Receiver with 40-GHz Sampling Clock and on-chip PLL

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. A 2-GHz Direct Sampling ΔΣ Tunable Receiver with 40-GHz Sampling Clock and on-chip PLL T. Chalvatzis1, T. O. Dickson1,2 and S. P. Voinigescu1 1 University of Toronto, Toronto, CA 2 now with IBM T.J. Watson Research Center, NY, USA

  2. Outline of Presentation • Motivation • Circuit design • Loop filter • PLL • Measurement results • Summary

  3. Motivation • Direct sampling receiver for 2-GHz radio with 60 MHz BW • CT BP ΔΣ ADC with SNDR of 55dB/60MHz [Chalvatzis et al., JSSC, May 2007] • Investigation of clock jitter impact with on-chip clock source

  4. System Architecture • 2-GHz Gm-LC BPF • Fourth order loop • 1-bit quantizer as DFF with FCLK=40GHz • RZ pulse DACs • 40-GHz VCO/PLL

  5. System Level Design • Design methodology in continuous-time • System level simulation for accurate analysis of loop delay • Loop coefficients: • Gm1=22mS, Gm2=15mS • Gfb1=50mS, Gfb2=150mS SNDR=61dB over 60 MHz in Matlab Simulink

  6. SNR vs clock jitter • Clock jitter effect simulated for FS=40GHz, OSR=333 • PLL jitter < 1.4 ps (rms) for 10 bits resolution Δ: quantizer step [Ortmanns et al., ISCAS 2003]

  7. SNR vs resonator Q • Quantization noise integrated over BW for FS=40GHz • Q >18 for 10 bits resolution

  8. Loop Filter • MOS-HBT cascode for high linearity and low noise • EF limit voltage headroom, current source adds noise Loop filter with EF

  9. Modified Loop Filter • MOS-HBT cascode for high linearity and low noise • EF limit voltage headroom, current source adds noise Modified Loop Filter

  10. D/A Converter – Quantizer • DAC and quantizer with MOS-HBT cascodes [Chalvatzis et al., JSSC, May 2007] • MOS on clock path to improve speed with low supply • HBT on data path for high gain DAC Latch

  11. Digital Receiver – PLL Blocks • 40-GHz PLL design from 2.5V challenging • Combination of MOS-HBT transistors in PLL blocks Resettable Latch

  12. Digital Receiver – PLL Blocks • 40-GHz PLL design from 2.5V challenging • Combination of MOS-HBT transistors in PLL blocks Charge Pump

  13. VCO • Colpitts VCO topology with HBT [Dickson et al., CSICS 2006] • VCO biased for minimum phase noise • Differential tuning with accumulation mode MOS varactors

  14. Fabrication and characterization of digital receiver

  15. ADC DIGITAL OUT RF IN PLL REF PLL SEL Fabrication • ADC with on chip VCO/PLL in STM 0.13μm SiGe BiCMOS • Power dissipation 2.19W from 2.5V • Chip size 1.59x2.39mm2

  16. PLL measurements • Phase noise/jitter measured on PLL test structure • RMS jitter: σt=849fs • Jitter limited SNR for Fo=2GHz and OSR=333 -> SNR=66.7dB

  17. VCO measurements • Phase noise < -103dBc/Hz at 1 MHz offset from 40-GHz carrier

  18. Spectrum measurement with PLL • ADC tested with external and on-chip clock • No significant degradation from on-chip clock • Feedthrough from 2.5GHz PLL reference does not degrade performance

  19. SFDR measurement SFDR=59dB

  20. SNDR measurement SNDR measured for FIN=2GHz, FS=40GHz SNDR = 59.8dB over 60 MHz

  21. Dynamic Range ADC noise floor the same (-65dBm/60MHz) when external and on-chip clock employed

  22. Digital Receiver Performance

  23. Conclusion • First mm-wave sampling ΔΣ digital receiver in any semiconductor technology • Digital receiver achieves 9.65-bit resolution over 60 MHz • Removing EF pair in filter helps to increase linearity of ADC loop filter • For 10-bits resolution, jitter from on-chip VCO/PLL not limiting performance • Noise floor set by resonator Q

  24. Acknowledgements • Nortel Networks for funding support • John Ilowski and Eric Gagnon for discussions • STMicroelectronics for chip fabrication • Prof Miles Copeland for advice on the manuscript • Ricardo Aroca for help with testing • CMC for CAD tools • Jaro Pristrupa for CAD support

More Related