1 / 15

CAEP Working Group 3 Emissions Technical Issues

This report highlights the responsibilities of ICAO Working Group 3 (WG3) in developing standards for aircraft engine emissions, reviewing measurement procedures, and recommending changes to Annex 16. It also discusses environmental problems, determining the environmental need, long-term emissions technology goals, regulated emissions, CO2 standards, alternative emissions methodology, and noise stringency. Conclusions and future work of WG3 are presented.

kcushman
Download Presentation

CAEP Working Group 3 Emissions Technical Issues

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. CAEP Working Group 3Emissions Technical Issues Robert J. Shuter Rapporteur WG 3

  2. WG 3 Responsibilities • develop standards for aircraft engine emissions • review the methodology for these standards • review measurement procedures • recommend changes to Annex 16,Volume II to the Convention on International Aviation, Aircraft Engine Emissions

  3. New Standards Three ICAO principles for new standards are: • Environmental need • Technically achievable • Cost effective

  4. Environmental Problems • Ground level pollution • Global climate change (Kyoto Protocol) • Growth of aviation

  5. Determining the Environmental Need • Research Focal Points • Focal Point on Liaison • Airport Air Quality Studies • IPCC Report • Kyoto Accord

  6. Aviation Technology • Manufacturer’s briefings • 20% improvement in aircraft efficiency between 1997 and 2015 • NOx reductions 30-50% below CAEP/2 limits by 2020 • Emissions reductions from advanced engine technology are not sufficient to counteract the projected growth of aviation

  7. Long Term Emissions Technology Goals • a task group has initiated work towards longer term framework of technology goals to reduce emissions • questioning the relationship between ICAO standards and technology development • believe that the development of emissions forecasting tools for aviation is ICAO’s responsibility

  8. Regulated Emissions • Smoke • Gaseous emissions: • Unburned hydrocarbons (HC) • Carbon monoxide (CO) • Oxides of nitrogen (NOx)

  9. Carbon Dioxide (CO2)Standard • WG3 was asked to consider a CO2 standard • CO2 emissions are directly related to fuel burn • Fuel efficiency is already high as a result of market economic pressures • Point certification for CO2 could drive manufacturers to meet compliance for this point at the expense of the overall missions efficiency

  10. The LTO Cycle • The landing, take-off cycle includes four phases of flight: modetimethrust • take-off 0.7 minutes 100% • climb 2.2 minutes 85% • approach 4.0 minutes 30% • taxi/ground idle 26.0 minutes 7%

  11. Alternative Emissions Methodology • address requirements for calculating emissions for cruise and climb phases of flight • use performance based procedures • need to define “worst case” certification points • develop method to estimate actual emissions

  12. Noise Stringency • WG3 was asked to examine the impact of noise stringency on emissions from aircraft • Generally more modern aircraft are more efficient (High bypass ratio) • Aggressive noise reduction could lead to increased emissions

  13. Conclusions Presented to CAEP • Need to review the validity of the existing LTO emissions certification regime • Good progress has been made on alternate emissions methodology and long term goals • No CO2 standard • No changes to Annex 16

  14. WG3 Future Work Program • Review current LTO cycle • Complete AEM task • Develop long term technology goals • Asses technology advances • Monitor atmospheric research • Investigate new NOx standard • Propose production cut-off for CAEP/4 std

More Related