1 / 8

Ch. 2: Dynamics: Tower Diameter

Units. F. Units. Eng. 1.0. ft/s & lb/ft 3. SI. 1.22. m/s & kg/m 3. Ch. 2: Dynamics: Tower Diameter. Check steady state simulation for Q max &  v. Column Hydraulics. Radfrac block Report  include hydraulic parameters Run simulation Results Radfrac Block Profiles

shauna
Download Presentation

Ch. 2: Dynamics: Tower Diameter

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. Units F Units Eng 1.0 ft/s & lb/ft3 SI 1.22 m/s & kg/m3 Ch. 2: Dynamics: Tower Diameter Check steady state simulation for Qmax & v

  2. Column Hydraulics • Radfrac block • Report •  include hydraulic parameters • Run simulation • Results • Radfrac Block • Profiles • Hydraulics tab • ASPENPLUS: 

  3. In-Class Exercise P = 2 bar sat’d liq 20 stages Feed = above stage 10 D = 11.8 kmol/hr RR = 1.5 Benzene 11.8 kmol/hr Toluene 11.8 kmol/hr

  4. In-Class Exercise

  5. In-Class Exercise AspenPlus Tray sizing

  6. Controller Type Kc (gain) I (reset time) F (filter) Flow 0.5 0.3 min 0.1 min Level (surge) 2 (reactor) 10 (others) See text Pressure 2 10 Chapter 3: Controller Tuning

  7. Chapter 3: Controller Tuning • F, P, L - are simple controllers • Temperature & Composition • More difficult • Why ? • A: lags or deadtime • Simulators respond instantaneously • To make more realistic • Add lag time in control loop • Table 3.1 Typical values Rest of Chapter 3: Tuning techniques

More Related